Yamaha R6 Cam sensor pullup?

For discussing how to choose sensors and create a wiring harness for all Bowling and Grippo versions of the MegaSquirt® EFI controller.
Forum rules
Read the manual to see if your question is answered there before posting. Many users will not reply if the answer is already available in the manual.

If your question is about troubleshooting, configuration, or tuning, you MUST include your processor type (MS-I or MS-II) and code version in your post. If your question is about PCB assembly or modifications, you must also include the main board version number (1.01, 2.2 or 3.0).

If you have questions about MS1/Extra or MS2/Extra code configuration or tuning, please post them at www.msextra.com Such questions posted here will be moved to: a temporary MSextra sub-forum, where they will be removed after 7 days

The full forum rules are here: Forum Rules, be sure to read them all regularly.
Post Reply
RanE5-CSU
MegaSquirt Newbie
Posts: 2
Joined: Mon Nov 30, 2009 3:12 pm

Yamaha R6 Cam sensor pullup?

Post by RanE5-CSU »

Hi guys,

I am completing the build on my MS2 from DIYAutoTune.com. I just have one final resistor to do: the pullup resistor for the hall effect sensor on the VR2 input.

Should I do a 1k resistor? Should it be on the 12v position or the 5v position? I believe it is a 5v sensor, but the directions state that for a hall effect crank sensor, it should be on 12v.

Thanks!

Ryan
Top
Matt Cramer
Super Squirter
Posts: 2951
Joined: Sat Jul 03, 2004 11:35 am

Re: Yamaha R6 Cam sensor pullup?

Post by Matt Cramer »

5 volts is fine for a 5V sensor.
Top
RanE5-CSU
MegaSquirt Newbie
Posts: 2
Joined: Mon Nov 30, 2009 3:12 pm

Re: Yamaha R6 Cam sensor pullup?

Post by RanE5-CSU »

Thanks Matt, Ill try that

Ryan
Top
Post Reply

Return to “Wiring and Sensors”