I got a project that runs on a ms-II pcb 3.57. anyhow I was curious since there is 2 wires that you run to the injectors. Could I run 1 set on one then run another set on the other. Am I able to tune each bank differently? Main reason I am asking is trying to get a big set of injectors to idle usually makes it not run as well. I have seen some people run 2 sets so they can run a smaller set for idle and then when the get into boost the second set kicks in for the additonal fuel needed.
Some info about the project.
http://www.fullsizechevy.com/showthread ... erado-SCSB
Dual Injectors on a turbo motor setup
Forum rules
Read the manual to see if your question is answered there before posting. Many users will not reply if the answer is already available in the manual.
If your question is about troubleshooting, configuration, or tuning, you MUST include your processor type (MS-I or MS-II) and code version in your post. If your question is about PCB assembly or modifications, you must also include the main board version number (1.01, 2.2 or 3.0).
If you have questions about MS1/Extra or MS2/Extra code configuration or tuning, please post them at www.msextra.com Such questions posted here will be moved to: a temporary MSextra sub-forum, where they will be removed after 7 days
The full forum rules are here: Forum Rules, be sure to read them all regularly.
Read the manual to see if your question is answered there before posting. Many users will not reply if the answer is already available in the manual.
If your question is about troubleshooting, configuration, or tuning, you MUST include your processor type (MS-I or MS-II) and code version in your post. If your question is about PCB assembly or modifications, you must also include the main board version number (1.01, 2.2 or 3.0).
If you have questions about MS1/Extra or MS2/Extra code configuration or tuning, please post them at www.msextra.com Such questions posted here will be moved to: a temporary MSextra sub-forum, where they will be removed after 7 days
The full forum rules are here: Forum Rules, be sure to read them all regularly.
-
DonTZ125
- Experienced Squirter
- Posts: 337
- Joined: Sat May 16, 2009 1:49 pm
- Location: Scarborough, ON
- Contact:
Re: Dual Injectors on a turbo motor setup
Hi, Ed.
What you are describing is 'Staged Injection'; as you say, you have one set of small injectors for low end tuneability, plus another set (often larger) for full WOT power. This is indeed supported in MS-II/Extra, but not in the standard MS-II code.
What you are describing is 'Staged Injection'; as you say, you have one set of small injectors for low end tuneability, plus another set (often larger) for full WOT power. This is indeed supported in MS-II/Extra, but not in the standard MS-II code.
-
Matt Cramer
- Super Squirter
- Posts: 2951
- Joined: Sat Jul 03, 2004 11:35 am
Re: Dual Injectors on a turbo motor setup
Standard MS2 code can get similar results if run in Dual Table mode. This gives you a separate VE table for each bank.
-
DonTZ125
- Experienced Squirter
- Posts: 337
- Joined: Sat May 16, 2009 1:49 pm
- Location: Scarborough, ON
- Contact:
Re: Dual Injectors on a turbo motor setup
I assume you would use 'additive' mode, with 'zeros' in the secondary map below your trigger point?