Hello,
I just built a MS-2 V3.0 for a 2G DSM 4G63. Using Tuner Studio for tuning. Everything works, engine starts, all the gauges are OK, but my O2 sensor is not reading. I tried downloading the firmware, calibrating the AFR table, selected different sensor and even setting my own AFR values;. I tested the AEM wideband with an multimeter and the output is OK. The problem is the that the MS is not reading. Looks like the MS is not reading anything. No matter what I do, the gauge stays in 10AFR in AFR gauge style and 0.0V in O2 sensor gauge style.
The problem again: MS is not reading voltage for the O2 sensor wire.
Is there any ways to test the MS board?
MDP
Orlando, FL
O2 input not reading!
Forum rules
Read the manual to see if your question is answered there before posting. Many users will not reply if the answer is already available in the manual.
If your question is about troubleshooting, configuration, or tuning, you MUST include your processor type (MS-I or MS-II) and code version in your post. If your question is about PCB assembly or modifications, you must also include the main board version number (1.01, 2.2 or 3.0).
If you have questions about MS1/Extra or MS2/Extra code configuration or tuning, please post them at www.msextra.com Such questions posted here will be moved to: a temporary MSextra sub-forum, where they will be removed after 7 days
The full forum rules are here: Forum Rules, be sure to read them all regularly.
Read the manual to see if your question is answered there before posting. Many users will not reply if the answer is already available in the manual.
If your question is about troubleshooting, configuration, or tuning, you MUST include your processor type (MS-I or MS-II) and code version in your post. If your question is about PCB assembly or modifications, you must also include the main board version number (1.01, 2.2 or 3.0).
If you have questions about MS1/Extra or MS2/Extra code configuration or tuning, please post them at www.msextra.com Such questions posted here will be moved to: a temporary MSextra sub-forum, where they will be removed after 7 days
The full forum rules are here: Forum Rules, be sure to read them all regularly.
Re: O2 input not reading!
OK, issue solved!
Calibrating the WB sensor needs to be done with the engine OFF, I did that. But when testing the sensor, the engine should be ON and running. This is the only way the O2 sensor gauge will work.
Thank you,
MDP
Orlando, FL
Calibrating the WB sensor needs to be done with the engine OFF, I did that. But when testing the sensor, the engine should be ON and running. This is the only way the O2 sensor gauge will work.
Thank you,
MDP
Orlando, FL