i have a olds 455 i am trying to put a ford edis ignition on.
i bought this
<eBay links not allo0wed on these forums>
36-1 6.75 inch wheel of of ebay. I need to drill mounting holes for it but i cant figure out where the missing tooth should be mounted in relation to TDC.
I've searched but cant come up with anything
thanks in advance
brad
36-1 wheel phasing
Forum rules
Read the manual to see if your question is answered there before posting. Many users will not reply if the answer is already available in the manual.
If your question is about troubleshooting, configuration, or tuning, you MUST include your processor type (MS-I or MS-II) and code version in your post. If your question is about PCB assembly or modifications, you must also include the main board version number (1.01, 2.2 or 3.0). For tuning/troubleshooting questions, please attached a datalog and your MSQ file to your post.
If you have questions about MS1/Extra or MS2/Extra code configuration or tuning, please post them at www.msextra.com Such questions posted here will be moved to: a temporary MSextra sub-forum, where they will be removed after 7 days
The full forum rules are here: Forum Rules, be sure to read them all regularly.
Read the manual to see if your question is answered there before posting. Many users will not reply if the answer is already available in the manual.
If your question is about troubleshooting, configuration, or tuning, you MUST include your processor type (MS-I or MS-II) and code version in your post. If your question is about PCB assembly or modifications, you must also include the main board version number (1.01, 2.2 or 3.0). For tuning/troubleshooting questions, please attached a datalog and your MSQ file to your post.
If you have questions about MS1/Extra or MS2/Extra code configuration or tuning, please post them at www.msextra.com Such questions posted here will be moved to: a temporary MSextra sub-forum, where they will be removed after 7 days
The full forum rules are here: Forum Rules, be sure to read them all regularly.
36-1 wheel phasing
92 zx7r ninja with 2007 gsxr TBs ms1 ver 2.2 fuel only
78 firebird olds 455 with holley 4d FI soon to be swapped to MS
78 firebird olds 455 with holley 4d FI soon to be swapped to MS
Re: 36-1 wheel phasing
http://www.megamanual.com/ms2/EDIS.htm
The picture shows the relationship between TDC, wheel and sensor for an 8 cylinder. Further down it gives the differences for 4 and 6 cylinder engines.
The picture shows the relationship between TDC, wheel and sensor for an 8 cylinder. Further down it gives the differences for 4 and 6 cylinder engines.
Dave P, London UK.
Rover V-8
MSII V3
EDIS
Tech Edge Wideband
Rover V-8
MSII V3
EDIS
Tech Edge Wideband
Re: 36-1 wheel phasing
so 5 teeth ahead of tdc
92 zx7r ninja with 2007 gsxr TBs ms1 ver 2.2 fuel only
78 firebird olds 455 with holley 4d FI soon to be swapped to MS
78 firebird olds 455 with holley 4d FI soon to be swapped to MS
Re: 36-1 wheel phasing
Yes. But note how that diagram is viewed.hessdawg wrote:so 5 teeth ahead of tdc
Dave P, London UK.
Rover V-8
MSII V3
EDIS
Tech Edge Wideband
Rover V-8
MSII V3
EDIS
Tech Edge Wideband