Hello. I want to use megasquirt system, but can't find some info about sensors.
For example: if i connect to megasquirt ignition only, what sensors do i need?
Or squirt only.
Can someone help me?
sorry for my bad English
Help me
Forum rules
Read the manual to see if your question is answered there before posting. Many users will not reply if the answer is already available in the manual.
If your question is about troubleshooting, configuration, or tuning, you MUST include your processor type (MS-I or MS-II) and code version in your post. If your question is about PCB assembly or modifications, you must also include the main board version number (1.01, 2.2 or 3.0).
If you have questions about MS1/Extra or MS2/Extra code configuration or tuning, please post them at www.msextra.com Such questions posted here will be moved to: a temporary MSextra sub-forum, where they will be removed after 7 days
The full forum rules are here: Forum Rules, be sure to read them all regularly.
Read the manual to see if your question is answered there before posting. Many users will not reply if the answer is already available in the manual.
If your question is about troubleshooting, configuration, or tuning, you MUST include your processor type (MS-I or MS-II) and code version in your post. If your question is about PCB assembly or modifications, you must also include the main board version number (1.01, 2.2 or 3.0).
If you have questions about MS1/Extra or MS2/Extra code configuration or tuning, please post them at www.msextra.com Such questions posted here will be moved to: a temporary MSextra sub-forum, where they will be removed after 7 days
The full forum rules are here: Forum Rules, be sure to read them all regularly.
-
Matt Cramer
- Super Squirter
- Posts: 2951
- Joined: Sat Jul 03, 2004 11:35 am
Re: Help me
The V3.0 wiring diagram on this page shows the standard sensors it would be using for fuel and ignition:practician wrote:Hello. I want to use megasquirt system, but can't find some info about sensors.
For example: if i connect to megasquirt ignition only, what sensors do i need?
Or squirt only.
Can someone help me?
sorry for my bad English
http://www.megamanual.com/v22manual/mwire.htm
The MAP sensor, being inside the MS, isn't shown. A fuel-only setup could use the V2.2 diagram instead, while an ignition-only setup can omit the IAT, CLT, O2, and TPS sensors.
-
practician
- MegaSquirt Newbie
- Posts: 3
- Joined: Thu Oct 21, 2010 8:21 am
Re: Help me
Thanks very much,
One question more:
Why isn't camshaft position sensor on picture (External Wiring)?
Is it not necessary?
One question more:
Why isn't camshaft position sensor on picture (External Wiring)?
Is it not necessary?
Re: Help me
It is shown as getting the tach signal from the coil. Other ignition systems are covered separately.practician wrote:Thanks very much,
One question more:
Why isn't camshaft position sensor on picture (External Wiring)?
Is it not necessary?
Dave P, London UK.
Rover V-8
MSII V3
EDIS
Tech Edge Wideband
Rover V-8
MSII V3
EDIS
Tech Edge Wideband