I have a V2.2 board that i installed MS2 on. Im am using the extra code and was bench checking my inputs and outputs. I just had what i thought was a finished setup when i noticed that the center chip, the one you have to modify for dual table is getting so hot that you cant touch it. I have been pulling my hair out and have disconnected EVERY add on wire that i have added, and its still happening.
Has anyone experianced this, did i checked my solder for the dual table? It looks good as far as i can see but something has to be wrong. Thanks
MS2 getting VERY HOT
Forum rules
Read the manual to see if your question is answered there before posting. Many users will not reply if the answer is already available in the manual.
If your question is about troubleshooting, configuration, or tuning, you MUST include your processor type (MS-I or MS-II) and code version in your post. If your question is about PCB assembly or modifications, you must also include the main board version number (1.01, 2.2 or 3.0).
If you have questions about MS1/Extra or MS2/Extra code configuration or tuning, please post them at www.msextra.com Such questions posted here will be moved to: a temporary MSextra sub-forum, where they will be removed after 7 days
The full forum rules are here: Forum Rules, be sure to read them all regularly.
Read the manual to see if your question is answered there before posting. Many users will not reply if the answer is already available in the manual.
If your question is about troubleshooting, configuration, or tuning, you MUST include your processor type (MS-I or MS-II) and code version in your post. If your question is about PCB assembly or modifications, you must also include the main board version number (1.01, 2.2 or 3.0).
If you have questions about MS1/Extra or MS2/Extra code configuration or tuning, please post them at www.msextra.com Such questions posted here will be moved to: a temporary MSextra sub-forum, where they will be removed after 7 days
The full forum rules are here: Forum Rules, be sure to read them all regularly.
-
Matt Cramer
- Super Squirter
- Posts: 2951
- Joined: Sat Jul 03, 2004 11:35 am
Re: MS2 getting VERY HOT
The 48 pin processor? Sounds like you damaged something soldering in those mods.
-
n20junkie
- MegaSquirt Newbie
- Posts: 2
- Joined: Tue Jun 15, 2004 10:48 am
- Location: Grand Island NY
- Contact:
Re: MS2 getting VERY HOT
The wierd thing is that EVERYTHING works, all the outputs, and so far the launch and nitrous inputs. The 5v regulator seems to be hot as well. I undid pretty much every external bit. I dont know if during my debuggins i damaged the MS2 and now its doing this to itself. For now i will run it and finish all testing, and then get a new chip to see if that fixes it. I will heat sink it to help it for now. If anyone more ideas i will try just about anything.