Hi everyone.
Car is 95 Eagle Talon, 420a with all the works. Anyway, I just wired in my MSII this week and am trying to iron out some issues. It seems that my MS isn't reading the 0-5V analog signal coming from my AEM unit (white wire). I have the white wire on the AEM going to the pink O2 wire on the MS harness. Gauge works fine like it always has but in TunerStudio the A/F gauge is very irradic and bouncing around the 16-17 mark no matter the condition. I tried calibrating to the preset AEM mode and nothing changed. Any input is appreciated. Thanks.
AEM Uego Signal Problem
Forum rules
Read the manual to see if your question is answered there before posting. Many users will not reply if the answer is already available in the manual.
If your question is about troubleshooting, configuration, or tuning, you MUST include your processor type (MS-I or MS-II) and code version in your post. If your question is about PCB assembly or modifications, you must also include the main board version number (1.01, 2.2 or 3.0).
If you have questions about MS1/Extra or MS2/Extra code configuration or tuning, please post them at www.msextra.com Such questions posted here will be moved to: a temporary MSextra sub-forum, where they will be removed after 7 days
The full forum rules are here: Forum Rules, be sure to read them all regularly.
Read the manual to see if your question is answered there before posting. Many users will not reply if the answer is already available in the manual.
If your question is about troubleshooting, configuration, or tuning, you MUST include your processor type (MS-I or MS-II) and code version in your post. If your question is about PCB assembly or modifications, you must also include the main board version number (1.01, 2.2 or 3.0).
If you have questions about MS1/Extra or MS2/Extra code configuration or tuning, please post them at www.msextra.com Such questions posted here will be moved to: a temporary MSextra sub-forum, where they will be removed after 7 days
The full forum rules are here: Forum Rules, be sure to read them all regularly.
-
Matt Cramer
- Super Squirter
- Posts: 2951
- Joined: Sat Jul 03, 2004 11:35 am
Re: AEM Uego Signal Problem
Check the voltage on the white wire to make sure it matches AEM's published output curve.
