VE Table changes
Moderator: LT401Vette
-
Robert Spencer
- MegaSquirt Newbie
- Posts: 27
- Joined: Fri Oct 19, 2007 6:42 pm
- Location: Washington ST.
VE Table changes
When I change the required fuel from 9.2 to 4.4, I get very large numbers in the VE table. I am changing from 20lb injectors to 42 lb for the new turbo addition. I would think the numbers would be smaller for larger injectors? Am I wrong?
Ghias Rule
-
Matt Cramer
- Super Squirter
- Posts: 2951
- Joined: Sat Jul 03, 2004 11:35 am
Re: VE Table changes
If you were using the "reset required fuel" command, this assumes you are changing Required Fuel *without* changing your injectors. Just change Required Fuel itself.
-
Robert Spencer
- MegaSquirt Newbie
- Posts: 27
- Joined: Fri Oct 19, 2007 6:42 pm
- Location: Washington ST.
Re: VE Table changes
Thanks Matt. Do I have to change required fuel in the ECU before it affects the VE table? Just doing that off line still gives me very large numbers.
Ghias Rule
-
Matt Cramer
- Super Squirter
- Posts: 2951
- Joined: Sat Jul 03, 2004 11:35 am
Re: VE Table changes
Exactly how are you changing Required Fuel?
-
Robert Spencer
- MegaSquirt Newbie
- Posts: 27
- Joined: Fri Oct 19, 2007 6:42 pm
- Location: Washington ST.
Re: VE Table changes
I go to injector control under fuel set up and enter the new injector size and it goes from 9.2 with the 20lb injector to 4.4 with the 42lb injector. I am working off line when doing this.
Ghias Rule
-
Robert Spencer
- MegaSquirt Newbie
- Posts: 27
- Joined: Fri Oct 19, 2007 6:42 pm
- Location: Washington ST.
Re: VE Table changes
Also when I check the required fuel under VE able, it shows the new number. I get numbers like 159, 147, ect. Can I do this with Tuner Studio?
Ghias Rule