ms2 3.57 board
Forum rules
Read the manual to see if your question is answered there before posting. Many users will not reply if the answer is already available in the manual.
If your question is about troubleshooting, configuration, or tuning, you MUST include your processor type (MS-I or MS-II) and code version in your post. If your question is about PCB assembly or modifications, you must also include the main board version number (1.01, 2.2 or 3.0).
If you have questions about MS1/Extra or MS2/Extra code configuration or tuning, please post them at www.msextra.com Such questions posted here will be moved to: a temporary MSextra sub-forum, where they will be removed after 7 days
The full forum rules are here: Forum Rules, be sure to read them all regularly.
Read the manual to see if your question is answered there before posting. Many users will not reply if the answer is already available in the manual.
If your question is about troubleshooting, configuration, or tuning, you MUST include your processor type (MS-I or MS-II) and code version in your post. If your question is about PCB assembly or modifications, you must also include the main board version number (1.01, 2.2 or 3.0).
If you have questions about MS1/Extra or MS2/Extra code configuration or tuning, please post them at www.msextra.com Such questions posted here will be moved to: a temporary MSextra sub-forum, where they will be removed after 7 days
The full forum rules are here: Forum Rules, be sure to read them all regularly.
ms2 3.57 board
IS THE PRE-ASSM. 3.57 MS 2 WIRED FOR VR. RUNNING A MSD 6AL /CRANK TRIGGER AND TWO HOLLEY TBI'S
-
Matt Cramer
- Super Squirter
- Posts: 2951
- Joined: Sat Jul 03, 2004 11:35 am
Re: ms2 3.57 board
Not by default (at least at our shop), but it can be special ordered that way.
Re: ms2 3.57 board
So, do I just need a Jumper wire to run a Vr. or do i need a diode or two. Running a 3.57pre assm, with a relay board , msd 6al and crank trigger. thanks Alan
-
Matt Cramer
- Super Squirter
- Posts: 2951
- Joined: Sat Jul 03, 2004 11:35 am
Re: ms2 3.57 board
How did you order this one?
Re: ms2 3.57 board
Matt, Ordered a Carb to EFI KIT. 3. 57 board and updated firmware 3.0 hooked up stim and everything works, i.e. temp tps, map.
-
Matt Cramer
- Super Squirter
- Posts: 2951
- Joined: Sat Jul 03, 2004 11:35 am
Re: ms2 3.57 board
That one would have been set up so it could run fuel only or a 7/8 pin HEI. If you are running an MSD box and not using the HEI module, you'd need to set the jumpers for VR input and install a switching transistor or BIP373 in the Q16 slot.
Re: ms2 3.57 board
Thanks Matt.