IAT and MAT?
Forum rules
Read the manual to see if your question is answered there before posting. Many users will not reply if the answer is already available in the manual.
If your question is about troubleshooting, configuration, or tuning, you MUST include your processor type (MS-I or MS-II) and code version in your post. If your question is about PCB assembly or modifications, you must also include the main board version number (1.01, 2.2 or 3.0).
If you have questions about MS1/Extra or MS2/Extra code configuration or tuning, please post them at www.msextra.com Such questions posted here will be moved to: a temporary MSextra sub-forum, where they will be removed after 7 days
The full forum rules are here: Forum Rules, be sure to read them all regularly.
Read the manual to see if your question is answered there before posting. Many users will not reply if the answer is already available in the manual.
If your question is about troubleshooting, configuration, or tuning, you MUST include your processor type (MS-I or MS-II) and code version in your post. If your question is about PCB assembly or modifications, you must also include the main board version number (1.01, 2.2 or 3.0).
If you have questions about MS1/Extra or MS2/Extra code configuration or tuning, please post them at www.msextra.com Such questions posted here will be moved to: a temporary MSextra sub-forum, where they will be removed after 7 days
The full forum rules are here: Forum Rules, be sure to read them all regularly.
-
somolovitch3
- MegaSquirt Newbie
- Posts: 2
- Joined: Fri Feb 10, 2012 5:15 pm
IAT and MAT?
I have an IAT located about 6" in front of the throttle plates. There is a place on the manifold for another sensor (MAT). Can one run both sensers at the same time? If so, how? High speed switching between the two? Just connect the two together? Naw, that would relly give a bad reading.
-
DonTZ125
- Experienced Squirter
- Posts: 337
- Joined: Sat May 16, 2009 1:49 pm
- Location: Scarborough, ON
- Contact:
Re: IAT and MAT?
There is only one place to wire in an air temp sensor, be it "Intake" or "Manifold". There has been some talk on the Other board about switching between sensors to deal with hot-restart heat soak issues, but I don't think anything has come of it.
-
somolovitch3
- MegaSquirt Newbie
- Posts: 2
- Joined: Fri Feb 10, 2012 5:15 pm
Re: IAT and MAT?
Are we talking about some kind of timer to switch from the MAT to the IAT for 5 min at start up? Use a thermo sensor to decide if the "switch" is needed?
Has anyone else gone crazy in this direction?
Has anyone else gone crazy in this direction?