I'm gathering some info before my build and my question is will this:
http://www.DIYAutoTune.com/catalog/64-p ... p-506.html
connect to the V3 board and fit inside the case in this:
http://www.DIYAutoTune.com/catalog/mega ... p-108.html
Obviously, I would have to cut a hole...but is there enough room to accommodate the connector? I've searched around but couldn't fine the answer I was looking for.
Thanks,
Don
stock connector in a kit case?
Forum rules
Read the manual to see if your question is answered there before posting. Many users will not reply if the answer is already available in the manual.
If your question is about troubleshooting, configuration, or tuning, you MUST include your processor type (MS-I or MS-II) and code version in your post. If your question is about PCB assembly or modifications, you must also include the main board version number (1.01, 2.2 or 3.0).
If you have questions about MS1/Extra or MS2/Extra code configuration or tuning, please post them at www.msextra.com Such questions posted here will be moved to: a temporary MSextra sub-forum, where they will be removed after 7 days
The full forum rules are here: Forum Rules, be sure to read them all regularly.
Read the manual to see if your question is answered there before posting. Many users will not reply if the answer is already available in the manual.
If your question is about troubleshooting, configuration, or tuning, you MUST include your processor type (MS-I or MS-II) and code version in your post. If your question is about PCB assembly or modifications, you must also include the main board version number (1.01, 2.2 or 3.0).
If you have questions about MS1/Extra or MS2/Extra code configuration or tuning, please post them at www.msextra.com Such questions posted here will be moved to: a temporary MSextra sub-forum, where they will be removed after 7 days
The full forum rules are here: Forum Rules, be sure to read them all regularly.
-
clutch dude
- MegaSquirt Newbie
- Posts: 1
- Joined: Fri Dec 04, 2009 12:11 pm
-
Matt Cramer
- Super Squirter
- Posts: 2951
- Joined: Sat Jul 03, 2004 11:35 am
Re: stock connector in a kit case?
It would need some jumper wires to connect it and you'd probably end up with the connector somehow attached to the lid, but I've seen similar things done.
