Basic question about flow rates

For discussing injector selection,manifold modifications, throttle bodies, fuel supply system design and construction, and FIdle valves and IACs.
Forum rules
Read the manual to see if your question is answered there before posting. Many users will not reply if the answer is already available in the manual.

If your question is about troubleshooting, configuration, or tuning, you MUST include your processor type (MS-I or MS-II) and code version in your post. If your question is about PCB assembly or modifications, you must also include the main board version number (1.01, 2.2 or 3.0).

If you have questions about MS1/Extra or MS2/Extra code configuration or tuning, please post them at www.msextra.com Such questions posted here will be moved to: a temporary MSextra sub-forum, where they will be removed after 7 days

The full forum rules are here: Forum Rules, be sure to read them all regularly.
Post Reply
trakkies
Super Squirter
Posts: 1162
Joined: Tue Dec 30, 2008 3:06 am
Location: SW London, UK

Basic question about flow rates

Post by trakkies »

Injector flow rate sites I've found quote lb/hr, cc/min, and gms. Tuner studio asks for g/s. Could you explain what this is and how it correlates to the above flow rates?
Dave P, London UK.
Rover V-8
MSII V3
EDIS
Tech Edge Wideband
Top
Bernard Fife
Master Squirter
Posts: 475
Joined: Thu Oct 29, 2009 12:54 pm

Re: Basic question about flow rates

Post by Bernard Fife »

See this: http://www.megamanual.com/mt29.htm#sg
"Never wrestle with pigs. You both get dirty and the pig likes it.” - George Bernard Shaw
Top
trakkies
Super Squirter
Posts: 1162
Joined: Tue Dec 30, 2008 3:06 am
Location: SW London, UK

Re: Basic question about flow rates

Post by trakkies »

Thanks Lance. I clicked on 'help' etc on the TS page, but for some reason didn't get the page you've given.'
Dave P, London UK.
Rover V-8
MSII V3
EDIS
Tech Edge Wideband
Top
Post Reply

Return to “Injectors, Fuel & Air Supply”