ok i have a ms2 v 3
setup goes as follows
1.5l 12v engine turbo hyundai
500cc inj
walbro 255
fpr
ok i just got evrything in running fuel only
i got it to run and idle kinda shitty now im trying to adjust stuff on the ve table but im lost
any one give me a hand maybee some sort of base map ?
need major help
Forum rules
Read the manual to see if your question is answered there before posting. Many users will not reply if the answer is already available in the manual.
If your question is about troubleshooting, configuration, or tuning, you MUST include your processor type (MS-I or MS-II) and code version in your post. If your question is about PCB assembly or modifications, you must also include the main board version number (1.01, 2.2 or 3.0). For tuning/troubleshooting questions, please attached a datalog and your MSQ file to your post.
If you have questions about MS1/Extra or MS2/Extra code configuration or tuning, please post them at www.msextra.com Such questions posted here will be moved to: a temporary MSextra sub-forum, where they will be removed after 7 days
The full forum rules are here: Forum Rules, be sure to read them all regularly.
Read the manual to see if your question is answered there before posting. Many users will not reply if the answer is already available in the manual.
If your question is about troubleshooting, configuration, or tuning, you MUST include your processor type (MS-I or MS-II) and code version in your post. If your question is about PCB assembly or modifications, you must also include the main board version number (1.01, 2.2 or 3.0). For tuning/troubleshooting questions, please attached a datalog and your MSQ file to your post.
If you have questions about MS1/Extra or MS2/Extra code configuration or tuning, please post them at www.msextra.com Such questions posted here will be moved to: a temporary MSextra sub-forum, where they will be removed after 7 days
The full forum rules are here: Forum Rules, be sure to read them all regularly.
Re: need major help
and heres the msq
You do not have the required permissions to view the files attached to this post.
-
Matt Cramer
- Super Squirter
- Posts: 2951
- Joined: Sat Jul 03, 2004 11:35 am
Re: need major help
1. It's idling too lean. Add more fuel at idle.
2. You are losing the RPM signal above 2000 RPM. If you are using a VR sensor, see this article on how to adjust the trim pots:
http://www.DIYAutoTune.com/tech_article ... _index.htm
2. You are losing the RPM signal above 2000 RPM. If you are using a VR sensor, see this article on how to adjust the trim pots:
http://www.DIYAutoTune.com/tech_article ... _index.htm
Re: need major help
thanks matt that whas what i needed to see
but theres 2 fixes
whitch should i start with
adjusting the pot with a o scope or placing a resistor inline with the cks
but theres 2 fixes
whitch should i start with
adjusting the pot with a o scope or placing a resistor inline with the cks