power wire with fuse

For discussing how to choose sensors and create a wiring harness for all Bowling and Grippo versions of the MegaSquirt® EFI controller.
Forum rules
Read the manual to see if your question is answered there before posting. Many users will not reply if the answer is already available in the manual.

If your question is about troubleshooting, configuration, or tuning, you MUST include your processor type (MS-I or MS-II) and code version in your post. If your question is about PCB assembly or modifications, you must also include the main board version number (1.01, 2.2 or 3.0).

If you have questions about MS1/Extra or MS2/Extra code configuration or tuning, please post them at www.msextra.com Such questions posted here will be moved to: a temporary MSextra sub-forum, where they will be removed after 7 days

The full forum rules are here: Forum Rules, be sure to read them all regularly.
Post Reply
johnnyb
MegaSquirt Newbie
Posts: 13
Joined: Mon Jun 20, 2011 1:55 pm

power wire with fuse

Post by johnnyb »

was wondering the red power wire if i run it to a switch that has all time 12 amps do i have to run a in line fuse from the red power wire to the 12v switch.
for the injectors wiring dose it take a 5 amp fuse or should i go bigger.
trakkies
Super Squirter
Posts: 1162
Joined: Tue Dec 30, 2008 3:06 am
Location: SW London, UK

Re: power wire with fuse

Post by trakkies »

The manual external wiring diagram shows recommended fuse positions and values.

http://www.megamanual.com/v22manual/mwire.htm#exwire
Dave P, London UK.
Rover V-8
MSII V3
EDIS
Tech Edge Wideband
Post Reply