Hello everyone I'm new to megasquirt, I've got a carbed sbc that I've got edis 8 working in limp mode no problem. I've got a 3.0 board with a relay board as we'll and I show RPM in tuner studio that matches my tach on my car. I've got the SAW wiring going to S5 on the relay terminal. But I'm showing no advance in timing. I've read a couple things on some settings to "use table" instead of "fixed" ignition settings but I can't seem to find that in tunerstudio lite. Is that something I need to upgrade the software to change? What else should I be looking at?
Heres my msq file. now as a background i got the ms2 off ebay from a guy who had a tbi sbc setup so theres all kinds of fuel settings and what not that i dont even need right now im only doing ignition first for the time being then ill switch to mpfi.
MS2 V3.0 EDIS NO SPARK ADVANCE
Forum rules
Read the manual to see if your question is answered there before posting. Many users will not reply if the answer is already available in the manual.
If your question is about troubleshooting, configuration, or tuning, you MUST include your processor type (MS-I or MS-II) and code version in your post. If your question is about PCB assembly or modifications, you must also include the main board version number (1.01, 2.2 or 3.0). For tuning/troubleshooting questions, please attached a datalog and your MSQ file to your post.
If you have questions about MS1/Extra or MS2/Extra code configuration or tuning, please post them at www.msextra.com Such questions posted here will be moved to: a temporary MSextra sub-forum, where they will be removed after 7 days
The full forum rules are here: Forum Rules, be sure to read them all regularly.
Read the manual to see if your question is answered there before posting. Many users will not reply if the answer is already available in the manual.
If your question is about troubleshooting, configuration, or tuning, you MUST include your processor type (MS-I or MS-II) and code version in your post. If your question is about PCB assembly or modifications, you must also include the main board version number (1.01, 2.2 or 3.0). For tuning/troubleshooting questions, please attached a datalog and your MSQ file to your post.
If you have questions about MS1/Extra or MS2/Extra code configuration or tuning, please post them at www.msextra.com Such questions posted here will be moved to: a temporary MSextra sub-forum, where they will be removed after 7 days
The full forum rules are here: Forum Rules, be sure to read them all regularly.
MS2 V3.0 EDIS NO SPARK ADVANCE
You do not have the required permissions to view the files attached to this post.
Re: MS2 V3.0 EDIS NO SPARK ADVANCE
IMHO it is far better to start afresh by re-loading the code and working from the base map there, going through the instructions in the manual for this. You already have saved out your existing MSQ, so can go back to it if needed. If the advance tables you have are good, you can load them into the new code.
Dave P, London UK.
Rover V-8
MSII V3
EDIS
Tech Edge Wideband
Rover V-8
MSII V3
EDIS
Tech Edge Wideband
Re: MS2 V3.0 EDIS NO SPARK ADVANCE
I've read up on fresh installations of code but I don't know how to remove and reinstall . Any links on that I was afraid to overwrite the old and cause more problems.