Hall sensor to Ford EDIS4 connections

For discussing how to choose sensors and create a wiring harness for all Bowling and Grippo versions of the MegaSquirt® EFI controller.
Forum rules
Read the manual to see if your question is answered there before posting. Many users will not reply if the answer is already available in the manual.

If your question is about troubleshooting, configuration, or tuning, you MUST include your processor type (MS-I or MS-II) and code version in your post. If your question is about PCB assembly or modifications, you must also include the main board version number (1.01, 2.2 or 3.0).

If you have questions about MS1/Extra or MS2/Extra code configuration or tuning, please post them at www.msextra.com Such questions posted here will be moved to: a temporary MSextra sub-forum, where they will be removed after 7 days

The full forum rules are here: Forum Rules, be sure to read them all regularly.
Post Reply
oldfart3
MegaSquirt Newbie
Posts: 1
Joined: Tue Jun 04, 2013 4:51 pm

Hall sensor to Ford EDIS4 connections

Post by oldfart3 »

I need guidance on connecting a DIY Hall sensor to a Ford EDIS4 module using DIY's wiring bundle.
Can anybody help?
Top
kjones6039
Master Squirter
Posts: 618
Joined: Sat Jul 22, 2006 7:02 pm
Location: Eureka, Nevada USA
Contact:
Contact kjones6039

Re: Hall sensor to Ford EDIS4 connections

Post by kjones6039 »

oldfart3 wrote:I need guidance on connecting a DIY Hall sensor to a Ford EDIS4 module using DIY's wiring bundle.
Can anybody help?
Will that work? Isn't the EDIS module going to be expecting a VR input? Very interesting......................

Ken
1979 Corvette - 383 CID SBC w/ Holley Pro-Jection 900 CFM TBI, 4-85 lb lo-z injectors & Walbro 255 pump
MS2 v3 w/ms2extra 3.4.0 Release
36-1, Delphi LS2/7 coils in wasted spark, driven by v2.0 logic board from JBPerformance
Spartan Lambda Sensor from 14point7
Top
Post Reply

Return to “Wiring and Sensors”