I am looking at the "General Settings" in TS and the injector flow rate is in (g/s). The injector I am using is rated at 222 cc/min. This comes out to about 0.0010 gallons per second (I used an online calculator).
Can this be right??????
I check the help page and seems to just skip this.
What am I missing? Thanks for any assistance.
units question TunerStudio
Moderator: LT401Vette
units question TunerStudio
1971 Honda N600
700 cc air cooled engine
36 Hp
700 cc air cooled engine
36 Hp
-
kjones6039
- Master Squirter
- Posts: 618
- Joined: Sat Jul 22, 2006 7:02 pm
- Location: Eureka, Nevada USA
- Contact:
Re: units question TunerStudio
I believe that measurement is grams/second, not gallons......
As you already know, there are any number of calculators online to do the conversion.
Ken
As you already know, there are any number of calculators online to do the conversion.
Ken
1979 Corvette - 383 CID SBC w/ Holley Pro-Jection 900 CFM TBI, 4-85 lb lo-z injectors & Walbro 255 pump
MS2 v3 w/ms2extra 3.4.0 Release
36-1, Delphi LS2/7 coils in wasted spark, driven by v2.0 logic board from JBPerformance
Spartan Lambda Sensor from 14point7
MS2 v3 w/ms2extra 3.4.0 Release
36-1, Delphi LS2/7 coils in wasted spark, driven by v2.0 logic board from JBPerformance
Spartan Lambda Sensor from 14point7
Re: units question TunerStudio
Got it. Thanks and I that is the second time I did that. Embarrassed.
1971 Honda N600
700 cc air cooled engine
36 Hp
700 cc air cooled engine
36 Hp