MS2 V3 Idle solenoid setup
Read the manual to see if your question is answered there before posting. Many users will not reply if the answer is already available in the manual.
If your question is about troubleshooting, configuration, or tuning, you MUST include your processor type (MS-I or MS-II) and code version in your post. If your question is about PCB assembly or modifications, you must also include the main board version number (1.01, 2.2 or 3.0).
If you have questions about MS1/Extra or MS2/Extra code configuration or tuning, please post them at www.msextra.com Such questions posted here will be moved to: a temporary MSextra sub-forum, where they will be removed after 7 days
The full forum rules are here: Forum Rules, be sure to read them all regularly.
MS2 V3 Idle solenoid setup
under "Idle Control" i selected Solenoids at 140* i can change my temp on the simulator and my LED on the megasquirt goes on and off as i go higher or lower on temp, but have no responce on the led in the simulator, , dont know what to select on the "Output Port Settings: menu and where does the signal comes out. thanks,
-
- Super Squirter
- Posts: 2951
- Joined: Sat Jul 03, 2004 11:35 am
Re: MS2 V3 Idle solenoid setup
Re: MS2 V3 Idle solenoid setup
Re: MS2 V3 Idle solenoid setup
Be sure to read Forum Rules here
