Have you used M'squirt with 911SC 6-pin CDI for both fuel & ignition control?Looking at the sc wiring diagram, it seems like you could run the dizzY (VR signal) to the MS tach input (pins 1&24) and then use the MS coil trigger output (pin 36) to trigger the CDI box at pin 7 of the CDI (dizzy green wire output)....but what do you do with CDI pin 31d (formerly the dizzy brown wire output ? ground? Or will the 6-pin CDI need a VR type output from the MS?
I've typically used MSD CDI units for this app, but I have a customer that wants to use the stock Bosch CDI and I have not used that particular configuration before.
If you have done this and/or have good relevant experience regarding this configuration........experts chime in please.
Note: link to Pelican parts forums...same question with wiring diagrams shown.............
regards,
al
http://forums.pelicanparts.com/porsche- ... n-cdi.html
Msquirt to Porsche 911SC 6 pin CDI
Forum rules
Read the manual to see if your question is answered there before posting. Many users will not reply if the answer is already available in the manual.
If your question is about troubleshooting, configuration, or tuning, you MUST include your processor type (MS-I or MS-II) and code version in your post. If your question is about PCB assembly or modifications, you must also include the main board version number (1.01, 2.2 or 3.0). For tuning/troubleshooting questions, please attached a datalog and your MSQ file to your post.
If you have questions about MS1/Extra or MS2/Extra code configuration or tuning, please post them at www.msextra.com Such questions posted here will be moved to: a temporary MSextra sub-forum, where they will be removed after 7 days
The full forum rules are here: Forum Rules, be sure to read them all regularly.
Read the manual to see if your question is answered there before posting. Many users will not reply if the answer is already available in the manual.
If your question is about troubleshooting, configuration, or tuning, you MUST include your processor type (MS-I or MS-II) and code version in your post. If your question is about PCB assembly or modifications, you must also include the main board version number (1.01, 2.2 or 3.0). For tuning/troubleshooting questions, please attached a datalog and your MSQ file to your post.
If you have questions about MS1/Extra or MS2/Extra code configuration or tuning, please post them at www.msextra.com Such questions posted here will be moved to: a temporary MSextra sub-forum, where they will be removed after 7 days
The full forum rules are here: Forum Rules, be sure to read them all regularly.