Page 1 of 1
How do I mount a TPS sensor on a Weber DCOE?
Posted: Tue Mar 14, 2006 11:19 am
by RdSnake
I'm looking for tips, designs or parts that will enable me to mount a TPS on a DCOE carb. Also, what would be the best TPS to use in terms of having the same amount of sweep as the DCOE and ease of mounting. TIA
Posted: Tue Mar 14, 2006 11:49 am
by Mike_Robert
If your application could use MAPdot as the AE triggering method, you might want to try that. Most apps using Webers are quite nonlinear re MAP/throttle opening. At low revs, a 15% opening of the throttles usually results in 100 kPa MAP w/ attendant AE requirements. Oh, and hardware wise, it's much easier as you already have a MAP sensor.
-Mike
Posted: Tue Mar 14, 2006 1:32 pm
by Pete M
Posted: Tue Mar 14, 2006 1:41 pm
by RdSnake
Application will be with MS-II v 3.0. The Webers will be used as throttle bodies and not be used for fuel delivery. The plan is to mount fuel injectors externally firing into the chokes.....
Posted: Tue Mar 14, 2006 1:58 pm
by Ralco_Be
I found this image on the net:
I dont know whitch vehicle and potentiometer it is, but even a normal remote potentiometer
can be used, using the right linkages.
Greetings.