Page 1 of 1
Widebind Lamda Wiring
Posted: Thu Jun 01, 2006 7:27 am
by kilvo
if i buy a wideband lamda sensor 4 wires do i connect signal and ground the the MS ECU then heater to Switched 12v and Ground thats all i do right.
im running V3 MsnsE Code MT225 2.016v C20XE Vauxhall Engine
Posted: Thu Jun 01, 2006 1:17 pm
by keithmac
Yep, thats about it! you may want to run the heater from the fuel pump relay (or at least a relay that`s switched when the fp is on) so when you`re in the car with the engine off but ignition on the O2 heater isn`t running.
Posted: Tue Jun 06, 2006 6:23 am
by kilvo
http://www.lambdasensor.com/main/mwide.htm
this is the one i was going to buy, can anyone confirm this is ok to use
Posted: Tue Jun 06, 2006 6:34 am
by kilvo
ignore my last post, it seems i need the controller to go with the above sensor, guess ill have to go shopping next week now
