VR to relay board wiring.
Posted: Wed Jul 12, 2006 3:55 pm
I have an MSII to be run through a relay board.
Question......when wiring the MSD's Pro Billet dizzy VR sensor, where do I run the wires in the relay board. I know the S5 is the output to the 6A and the pin 15 (tach/ignition) is the input (where i am guessing i would run the positive violet wire). But where is the green wire grounded to?
Can I run it to an empty s1-s4 pin and then through the "RELAY to MS" cable run it to an available ground on the MS?
Thanks,
Chris
Question......when wiring the MSD's Pro Billet dizzy VR sensor, where do I run the wires in the relay board. I know the S5 is the output to the 6A and the pin 15 (tach/ignition) is the input (where i am guessing i would run the positive violet wire). But where is the green wire grounded to?
Can I run it to an empty s1-s4 pin and then through the "RELAY to MS" cable run it to an available ground on the MS?
Thanks,
Chris