MSefi.com read only forum (Jan.15,2018)

This might already have been discussed but could not find any thing. I am going to be running MSII prob V3 with a relay board. I am going to use a locked Ford Duraspark with a GM 8 pin module to control the timing. My question is how do you wire the module into the relay board? I understand most of the other wiring that goes into the board. With most of the info on the website talks about the module going striaght into the MSII. Any info would be great.

Aaron

What is the best way to modify this to supply the 5V to the Fidle port? Thanks for all of your help.

Aaron

I installed this jumper from the "GV"middle terminal to position 20 on the terminal block. Is this all that is reguired for an 8 pin HEI to use the Fidle relay? I have seen 1K resistors and such on other forums plus I don't see any reference for HEI in the spare port settings. Rich