Page 1 of 1
GM CLT in a 9a 16V jetta
Posted: Thu Jan 04, 2007 6:44 pm
by NastnaS
hey guys
just wondering if anyone is using the GM sensor in there 16V?
also where did you put the sensor? [excuse the stupid quetion]
thanks
Posted: Thu Jan 04, 2007 7:40 pm
by renns
Nastnas,
You can in all likelihood use the stock sensor. Check the factory service manual for specs to be sure it's an NTC type (resistance increases when temp decreases and vice versa). Then use EasyTherm or the MSII equivalent to generate the required custom thermistor tables. See the megamanual for more details.
Roger.
Posted: Thu Jan 04, 2007 8:26 pm
by NastnaS
renns wrote:Nastnas,
You can in all likelihood use the stock sensor. Check the factory service manual for specs to be sure it's an NTC type (resistance increases when temp decreases and vice versa). Then use EasyTherm or the MSII equivalent to generate the required custom thermistor tables. See the megamanual for more details.
Roger.
thanks mate