MSefi.com read only forum (Jan.15,2018)

Simple question, on MS2 v3, I currently have my Fidle solenoid wired using the FIDLE output as ground activation to my relay. I would like to give my PWM idle valve a shot, so I just want to confirm that I will bypass the relay, use the same FIDLE output as ground directly to the valve and the other pin of the valve will be 12V?

Again, sorry but I couldn't find this info clearly on the assembly or tuning manual. Thanks!

richiea,
What you are looking for is probably at the end of this link:

http://www.megamanual.com/ms2/IAC.htm#fidle

Do not forget to put the diode across the idle valve wires. This is for flyback protection.

Charles.