Page 1 of 1
running gm hei with 6a
Posted: Sat Feb 24, 2007 7:40 am
by bluesilver91
alright ive been tring to figure alot of this out myself but i figured i would ask on this because im afraid the 6a might fry the ms II if i hook it up wrong. but i looked in the mega manual and just saw the diagram for a points style ignition. can anyone shed some light on this?
thanks steve
Posted: Sat Feb 24, 2007 8:02 am
by TT350chevelle
Posted: Sat Feb 24, 2007 10:05 am
by sharkey
im running an msd 6al/ 2 plug blaster coil with my 8 pin hei and megasquirt. what i did was got the msd plug and play harness, and i ran the 6al with my stock computer that way. when i put the ms in i just left it wired that way. basicly just wire it up the way it says in the msd instructions.
Posted: Sat Feb 24, 2007 6:37 pm
by bluesilver91
i did see that i just have a 8 pin hei, and when i wired the msd box when it had the stock ecm i jut tapped in the wires where th directions called for, can i just run the wires like called for in the gm 8 pin
Posted: Sat Feb 24, 2007 6:44 pm
by sharkey
it wired the exact same way as with a stock computer.
Posted: Sun Feb 25, 2007 6:24 pm
by bluesilver91
ok thanks