Page 1 of 1
EDIS sheilded wires
Posted: Tue Oct 23, 2007 2:50 am
by I-W
how important is the sheilding of these wires? i got a EDIs for cheap and it is 80% installed i just need to finish the harness. some of the sheilded wire is not covered all the way. will this be a problem?
thanks.
Posted: Wed Oct 24, 2007 1:23 am
by FridgeFreezer
The crank sensor (VR sensor) wire needs to be shielded.
Posted: Wed Oct 24, 2007 2:57 am
by I-W
it is all but like an inch or 2 where i had to solder wires together. hope thats not a problem.
Posted: Wed Oct 24, 2007 6:46 am
by FridgeFreezer
Should be OK.