Page 1 of 1
Is this tooth wheel ok?
Posted: Fri Nov 23, 2007 7:13 pm
by nachoF1
Hi! i´m above to run a MS-II PCB 3.0 in a 4 cylinder engine. My question is if I can use a 62 -2 tooth wheel at 10.000 RPM and if it works well, I´ll use a VR sensor for the signal, thanks!
Posted: Sun Nov 25, 2007 11:03 am
by FiatFreak
Hi there,
I've not heard of any RPM issues with the toothed wheels. If you are really concerned about it though, you could set up the wheel on the bench and see how it behaves at higher RPM. Not sure if you can get something to spin it 10k RPM though, that is pretty fast.
-Patrick-
Posted: Mon Nov 26, 2007 8:12 am
by nachoF1
ok! thank you very much, i´ll test it with the tester made with the audio card, thanks!
Posted: Fri Nov 30, 2007 2:31 pm
by steve_d
An angle grinder will run up to those sort of revs but I don't want to be in you r workshop when you try it.
Steve