Page 1 of 1
AMC and two tables
Posted: Wed Jul 30, 2008 4:08 am
by markthepadrone
Does AMC work with two tables?
My VE1 seems to improve but VE2 doesn't.
Re: AMC and two tables
Posted: Wed Jul 30, 2008 4:16 am
by grippo
It does, but I think you have to set the dual table option.
Re: AMC and two tables
Posted: Wed Jul 30, 2008 6:50 pm
by markthepadrone
I have dual tables set. O2 correction on table 1 seems to go down but table 2 always seems to need the same amount of correction.
Re: AMC and two tables
Posted: Thu Jul 31, 2008 4:40 am
by grippo
In looking at the code both VE tables are updated at the same time provided you have specified a dual ego option - either 2 NBs or 2 WBs, and you have a valid signal on each - that is a voltage that is not very close to 0 and not very close to 5V.
Re: AMC and two tables
Posted: Fri Aug 01, 2008 6:39 pm
by markthepadrone
Thanks.
I was having a problem with the latest firmware in the LC-1s.
The right O2 sensor was giving wacky readings so it was always trying to correct.