MSefi.com read only forum (Jan.15,2018)

hello.


I will begin to tune an engine for afr.I bought a o2 LC1 to diyoutune and have read the manual, I have more or less clear how to do it.
on the spark he also read, this engine has a knock three wires that goes straight home to the ecu, the manual says to put a knock GM with a driver, I have many doubts as to adjust the spark, and how to configure and install the knock, origin or when GM and know that this detonating the engine, someone can guide a bit?.
I have also seen a link of the handbook a module that connects with an outside MS2 led to see when the engine detonates, but as in MS2 detonates when it must be said (in my country we say sting), to know this must be done a DATALOG or something and see the peaks of pressure, and say when we feel that detonates.
of course without EGT, but I also read that with the warming of the O2 can I get an idea of the temperature of the exhaust, but will not be very accurate but can serve as guidance.

can you help me?, I am concerned about the pitch of the spark, thanks.

Nobody can orientate me with the sensor of detonation.
And well-read on snocksense, but I have doubts:
- to install with my sensor of detonation, valeo 2 cables.
- the page of snocksense says that a led is ignited when there is detonation, but it is with all the sensors and cylinder capacities equally.
If someone it to used you can say to me since it works thank you.