MSefi.com read only forum (Jan.15,2018)

i am running a msII controller with version 2.886 code from B&G. i would like to use a mallory hifife cd ing contoller with my ing setup but did not see any information withen the manual on how to set it up. from whit i can tell, i think it should be hooked up the same as the msd6 becouse these two controlles are preatty much the sam just diffrent beands. was wondering if i am correct in this or if their are differnt settting for the two controlles.


thanks
1983 f250
351 windsor
4 spd granny trans ( used for pullin)
gm throttle body and sensors
mallory hifire6
msd blaster coil
stock dizzy with adv removed

one outher question i forgot is can a low dwell setting cause a missfire at high rmp and not at idle?

It's wired up like an MSD 6. Also like an MSD 6, it does not really react very much to dwell settings unless there's something very strange about them. How are your dwell and maximum spark duration settings set?

i have them both set to 3.4 that is what the coil specs are without the controller i did this that way if the controler goes bad i can rewire it and go and when i used this controler before ms it worked fine

the truck does run the way i have it wired, but i am having trouble with the timming at idle i have it set to 10 btc it reads that with both the light and on the dshboard of megatune but as i rev up the light does not match the megatune dashboard the light will read 22 degrees at 2500 and megatune will read 33 degrees and i cant figuer out why tried all the differnt trigger input edges and the coil charging schems and it did not fix the problem. I posted a copy of the msq mabie i missed sometihing

Try adjusting the signal delay parameters under Advanced Ignition Options.

I tried to adjust teh sugnal delay but it dosen't seam to do anything, but i did notice that the red light on the mallory that is supposde to be a constient red when running (flashes with every spark signal so it appears as alays on) at the higher rpm's starts to flicker as if it were loosing signal and i don't understand why it is triggared directly off the msII controller without a module using the white advance wire i'm starting to wonder if it is a problem with the imput from the dizzy i used shielded wire to prevent interfearance. is their some kind of mod that needs to be done for the ford dizzy with a vr sensor to work corectly that i might have overlooked?