MSefi.com read only forum (Jan.15,2018)

Set up is supercharged EFI, can I place the O2 sensor in a single tube?? I know the the controller would tune the A/F ratio to
just that cylinder. However if air and fuel distribution are good all cylinders will have the same tune, correct?? This motor runs idle or WOT 3600 to 6000 rpm. I am long time racer but new to this board and to the EFI technology.

That should work, though keep in mind you'll probably see a bit of reversion at the end of the pipe at low RPM.

Thanks Matt

The project is still in the parts and pieces collection and design stages and I have three other cars to build this year. I'll keep the board posted and I'm sure have other question as it goes along.

Jim