Page 1 of 1
Need to recalibrate after code version upgrade?
Posted: Sat Mar 14, 2009 3:18 pm
by pickett
Just curious. I usually have to do at least some recalibration of VE or warmup table values after even a minor code version upgrade. Does anyone else experience this or should I try to track down something strange about my setup? Thanks.
Re: Need to recalibrate after code version upgrade?
Posted: Sat Mar 14, 2009 5:21 pm
by Bruce Bowling
No, none of the recent code changes should affect fuel settings. I never have to change any fuel settings and I burn all the time.
What you could do is datalog at idle warmed up with the old code, do the upgrade, and datalog again to see what is different.
- Bruce
Re: Need to recalibrate after code version upgrade?
Posted: Sat Mar 14, 2009 6:43 pm
by pickett
Thanks Bruce. I'll check it out.