Page 1 of 1
MS II will not calibrate AFR for WB under tools?
Posted: Wed Mar 18, 2009 10:57 am
by wiseguy
Hello,
I installed an LC-1 wideband O2 on my MS II. I changed from narrow band to LC-1 wideband in the configurator file, and the virtual dash displays correct voltage range for wideband. I have set the EGO steps, % and (simple). My problem is the last step mentioned for installation of wideband, when I choose wideband LC-1, 0-5v's (calibrating AFR under tools) It runs a bunch of numbers and goes back to the narrowband heading of the drop down menu? MS is powered up.
Re: MS II will not calibrate AFR for WB under tools?
Posted: Wed Mar 18, 2009 9:19 pm
by oughtsix
I had the same problem way back when. Forget what it was though.
Did you setup the settings.ini file for LC-1 wideband in mega config program?
Re: MS II will not calibrate AFR for WB under tools?
Posted: Thu Mar 19, 2009 5:09 am
by Matt Cramer
wiseguy wrote:Hello,
I installed an LC-1 wideband O2 on my MS II. I changed from narrow band to LC-1 wideband in the configurator file, and the virtual dash displays correct voltage range for wideband. I have set the EGO steps, % and (simple). My problem is the last step mentioned for installation of wideband, when I choose wideband LC-1, 0-5v's (calibrating AFR under tools) It runs a bunch of numbers and goes back to the narrowband heading of the drop down menu? MS is powered up.
Which menu is this? It doesn't really "remember" the settings on the Calibrate AFR Table menu in MegaTune but they are stored in the MS.
Re: MS II will not calibrate AFR for WB under tools?
Posted: Sun Mar 22, 2009 1:42 pm
by wiseguy
Thanks Matt,
Like you say it doesn't remember, but everything seems to work fine.
Thanks
Matt Cramer wrote:wiseguy wrote:Hello,
I installed an LC-1 wideband O2 on my MS II. I changed from narrow band to LC-1 wideband in the configurator file, and the virtual dash displays correct voltage range for wideband. I have set the EGO steps, % and (simple). My problem is the last step mentioned for installation of wideband, when I choose wideband LC-1, 0-5v's (calibrating AFR under tools) It runs a bunch of numbers and goes back to the narrowband heading of the drop down menu? MS is powered up.
Which menu is this? It doesn't really "remember" the settings on the Calibrate AFR Table menu in MegaTune but they are stored in the MS.
Re: MS II will not calibrate AFR for WB under tools?
Posted: Sun Mar 22, 2009 2:04 pm
by wiseguy
Yes I did,
Its like Matt said it doesn't remember it in the AFR calibration, but it retains it in MS and works fine. Thank You
oughtsix wrote:I had the same problem way back when. Forget what it was though.
Did you setup the settings.ini file for LC-1 wideband in mega config program?