Page 1 of 1
MS2-V3: Testing Ignition with Stim
Posted: Thu Mar 19, 2009 6:57 am
by patrickbrown
I don't think my ignition is working. I have built with the hall and VR circuit. I have it jumpered to use hall circuit. I have the stim ver 2.21 with five lights. Yje IGN light stays lit regardless of RPM. Is this a software setting or did I miss something in the build?
I'm running 2.888 code.
Re: MS2-V3: Testing Ignition with Stim
Posted: Thu Mar 19, 2009 11:11 am
by Matt Cramer
If you change the Spark Output from Going Low to Going High or vice versa, does the LED go out?
Re: MS2-V3: Testing Ignition with Stim
Posted: Thu Mar 19, 2009 1:43 pm
by patrickbrown
I had it set to "Going High (Inverted)" for EDIS support. I changed it to "Going Low (Normal)" and reset the MS. The IG LED blinks now and the rate follows the RPM knob. It seems to work. I change it back to Going High.
Thanks,
Re: MS2-V3: Testing Ignition with Stim
Posted: Mon Mar 23, 2009 6:34 am
by Matt Cramer
Sounds like all is working. Some settings just plain don't make the light blink in a way that's perceptible without an oscilloscope.
Re: MS2-V3: Testing Ignition with Stim
Posted: Mon Mar 23, 2009 8:36 am
by patrickbrown
Thanks Matt.