MSefi.com read only forum (Jan.15,2018)

I have an 81 scirocco with an aba 2.0L an a T 25 tubo. Im just curious if anyone has some maps that nay be close for me to start from. The car does run now but Im havin issues tuning when i get into the boost.I am running 25.2lb injectors. I did upgrade to a 4 bar regulator. Also i am running at 9:1 compression. Any help would be appreciated. thx.

While I don't have a map for this, I may be able to help figure out what's going on if you post a data log of the problem happening along with your MSQ file.

Thx for the reply. I will get a datalog as soon as i possible to post. I am currently running code 2.687. one of my issues that i did realize is that I needed to edit my ve map bins so as to be able to tune under boost. Obviously my "red dot" was running right off the table.This was most likley the biggest cause of my issues. As you can tell this is all new to me so please bare with me.

I have made some progress since the last post. I have however not taken a datalog. I replaced my injectors with some 48 lb ones and edited my map bins an now am having a much easier time. There is a vw club cruise this weekend and I hope to get a better tune by then. Im sure I could still use some help at that point. I will post a datalog and my MSQ after the cruise.

I seem to be having issues with the data logging in MLV. I cant find my saved files. They are not in the project file. Im thinking its an issue with MLV and windows vista. I have a post under the data logging section of the forum. The title is help with data logging. Appreciate some help thx in advance.