ms2 v3, step 23 no ground?
Forum rules
Read the manual to see if your question is answered there before posting. Many users will not reply if the answer is already available in the manual.
If your question is about troubleshooting, configuration, or tuning, you MUST include your processor type (MS-I or MS-II) and code version in your post. If your question is about PCB assembly or modifications, you must also include the main board version number (1.01, 2.2 or 3.0).
If you have questions about MS1/Extra or MS2/Extra code configuration or tuning, please post them at www.msextra.com Such questions posted here will be moved to: a temporary MSextra sub-forum, where they will be removed after 7 days
The full forum rules are here: Forum Rules, be sure to read them all regularly.
Read the manual to see if your question is answered there before posting. Many users will not reply if the answer is already available in the manual.
If your question is about troubleshooting, configuration, or tuning, you MUST include your processor type (MS-I or MS-II) and code version in your post. If your question is about PCB assembly or modifications, you must also include the main board version number (1.01, 2.2 or 3.0).
If you have questions about MS1/Extra or MS2/Extra code configuration or tuning, please post them at www.msextra.com Such questions posted here will be moved to: a temporary MSextra sub-forum, where they will be removed after 7 days
The full forum rules are here: Forum Rules, be sure to read them all regularly.
-
mister_tom
- MegaSquirt Newbie
- Posts: 4
- Joined: Wed Sep 30, 2009 6:18 am
ms2 v3, step 23 no ground?
got to step 23 of the assembly instructions where it asks to verify the supply is operational, on testing im getting + voltage on pins 1-2, 19-20 and 31-32. ive run through the instructions from the beginning up to this point several times and cant find a reason to why this is happening. any ideas what may be causing the problem?
-
mister_tom
- MegaSquirt Newbie
- Posts: 4
- Joined: Wed Sep 30, 2009 6:18 am
Re: ms2 v3, step 23 no ground?
ahhh found the problem, i didnt think the power jack was neccesary on the stimulator so left it off, just check the schematics and realised it is needed for ground. its all measuring up as it should now! i wont have damaged any other components by doing this though will I?