MSefi.com read only forum (Jan.15,2018)

In the ms wiring diagram injector pins 32 and 33 (and 34 and 35) are bridged together. Is this necessary? I'm connecting MS to my stock L-jet wiring harness and there is has separate wires for each injector. So my question is, is it safe to connect the injectors like so:

pin 32 - injector 1
pin 33 - injector 2
pin 34 - injector 3
pin 35 - injector 4

MadMax78,

Yes, you can do this. It works fine for 4 cylinders.

When you have an odd number of cylinders this doesn't work so well, because the point of bridging the pins is to even the electrical load on the connector pins (the pins are rated at 5 Amps each).

With 4 cylinders and one pin per injector, the load should be balanced anyhow, so you don't need to bridge the pins.

Lance.

Thanks for the quick and helpfull reply!

Just finishing up on my final wiring diagram now