Hi,
I was nearing the end of a 2 hour drive when I noticed on my Megaview that my AFR was stuck at 13.4. Shortly after this the car started lurching, coughing etc. It actually stopped the minute I pulled into my garage! After I unpacked the car I restarted her and everything was perfect - idling fine, AFR responding as expected.
Any thoughts what to look for here? I've had my MS2/MV installed for some months now without seeing this before. We did experience some heavy rain towards the end which might indicate a bad connection somewhere?
Oh it's a standard Innovate LC-1 WB setup.
Cheers,
AFR stuck at 13.4 after a long drive
Forum rules
Read the manual to see if your question is answered there before posting. Many users will not reply if the answer is already available in the manual.
If your question is about troubleshooting, configuration, or tuning, you MUST include your processor type (MS-I or MS-II) and code version in your post. If your question is about PCB assembly or modifications, you must also include the main board version number (1.01, 2.2 or 3.0).
If you have questions about MS1/Extra or MS2/Extra code configuration or tuning, please post them at www.msextra.com Such questions posted here will be moved to: a temporary MSextra sub-forum, where they will be removed after 7 days
The full forum rules are here: Forum Rules, be sure to read them all regularly.
Read the manual to see if your question is answered there before posting. Many users will not reply if the answer is already available in the manual.
If your question is about troubleshooting, configuration, or tuning, you MUST include your processor type (MS-I or MS-II) and code version in your post. If your question is about PCB assembly or modifications, you must also include the main board version number (1.01, 2.2 or 3.0).
If you have questions about MS1/Extra or MS2/Extra code configuration or tuning, please post them at www.msextra.com Such questions posted here will be moved to: a temporary MSextra sub-forum, where they will be removed after 7 days
The full forum rules are here: Forum Rules, be sure to read them all regularly.
-
pocketscience
- MegaSquirt Newbie
- Posts: 2
- Joined: Mon Sep 08, 2008 9:31 pm
- Location: Sydney, Australia
-
Matt Cramer
- Super Squirter
- Posts: 2951
- Joined: Sat Jul 03, 2004 11:35 am
Re: AFR stuck at 13.4 after a long drive
One tip - you can check the LC-1's output with LogWorks to see if the LC-1's actual readings are stuck or if the MegaSquirt is getting the wrong signal.
It'll be hard to nail this one down without being able to capture a data log of the problem happening.
It'll be hard to nail this one down without being able to capture a data log of the problem happening.
-
pocketscience
- MegaSquirt Newbie
- Posts: 2
- Joined: Mon Sep 08, 2008 9:31 pm
- Location: Sydney, Australia
Re: AFR stuck at 13.4 after a long drive
Thanks Matt - figured unless someone had seen this exact thing before it'd be impossible to guess where the problem might lay. I'll just keep an eye on it and hopefully next time it happens I have my lappie in range.
Cheers,
Cheers,