Is using the same vacuum port for MAP sensor + FPR OK?
Posted: Sat Feb 27, 2010 6:49 am
Hi all,
I have one threaded hole in my plenum in which I can bolt in a fitting and then connect a vacuum line. I need vacuum for MAP and fuel pressure regulator. Is it ok to plug in a T in the MAP sensor vacuum line to connect the FPR or will the two connected to the same source alter the vacuum value for eachother? In other words should I drill and thread another hole in the plenum for the FPR? If I can avoid it's better because taking the plenum out is a pain.
Thanks!
I have one threaded hole in my plenum in which I can bolt in a fitting and then connect a vacuum line. I need vacuum for MAP and fuel pressure regulator. Is it ok to plug in a T in the MAP sensor vacuum line to connect the FPR or will the two connected to the same source alter the vacuum value for eachother? In other words should I drill and thread another hole in the plenum for the FPR? If I can avoid it's better because taking the plenum out is a pain.
Thanks!