MSefi.com read only forum (Jan.15,2018)

Hi,
Just a question : how do you connect the coolant gauge signal from engine to megasquirt and to the gauge on the dash board ?
in parralel or a second sensor is neccessary?
regards
Didier ( France )

Didier,

Normally you use a second sensor. You might be able to use the same sensor, but you need to make sure they won't interfere with each other's supply voltage. This can be complicated. For a start, see this: http://www.megamanual.com/v22manual/sharesen.htm

Lance.

thank you for the fast answer, i think i'll go with two sensors, it's more easy and secure
bye bye
Didier ( MS2/EDIS 6 on L6 datsun Z in few months ).