troubleshooting the 31 and 32 pin

[rfrench]

Im assembling the ms2 with the v3.0. im at step 23 where it tells me to check the voltages at these pins. this is what i get

Pin
ground
________ 2_____19___32
1
(5 Volt) __5__ __5__ __0__
20
(5 Volt) __5__ __5__ __0__
31
(5 Volt) __0__ __0__ __0__

1. i checked the all the solder and did not see any bridging.
2. i did install the iac jumpers
3. i did check the voltage regulator and on the pin closet to the db9 is ~10.5v
on the far pin its 5v
and on the center pin i got around .1 ohm
im just not sure why im not getting any voltage at the 31 and 32 pins

[Matt Cramer]

Check L2, make sure it's not broken and has continuity from end to end. Also check the socket for cold solder joints.

[rfrench]

i checked L2 and there is ~.2 ohm resistance i also double checked the 40 pin for cold solders but still the same results

[rfrench]

i checked c15 and it has no resistance so im assuming its bad... the issue is do i replace it with one of the other ones and if so do i order another cap .1uF 50V 10% cer rad

[rfrench]

why would pin 31 act up if its just suppose to be a ground?

[rfrench]

thanks matt i just counted the pins in the wrong direction.