Adding ignition control to an MS-II in a MS-1 v2.2 board
Posted: Sat Apr 24, 2010 3:01 pm
I'm looking at upgrading my board to control my GM HEI distributor and was told I need to connect a wire from the JP1-Pin 5 to the #36 PIN on the DB37 connector at the board.
Wanted to know if there was a nice, simple plug to use on the JP1 Pin 5 terminal instead of soldering a wire directly to it?
I saw on DIY Autotune's website they have a "mod kit" for the GM HEI but I don't believe it will work with my board considering the one they show in the video looks different than mine.
Attached is a picture of where I was told to attach the wire on the JP1 terminal.
Thanks for the help,
Wanted to know if there was a nice, simple plug to use on the JP1 Pin 5 terminal instead of soldering a wire directly to it?
I saw on DIY Autotune's website they have a "mod kit" for the GM HEI but I don't believe it will work with my board considering the one they show in the video looks different than mine.
Attached is a picture of where I was told to attach the wire on the JP1 terminal.
Thanks for the help,