Page 1 of 1
Accel wizard.. MAP vs TP??
Posted: Sun May 16, 2010 6:47 pm
by HPjunkie
I have a stumble off of idle and and its not quite crisp enough.It doesnt "crack" when you hammer it. Its a light Manx style buggy and has a turboed 2332. any things you can steer me to on the megasquirt. I am a little confused aboutwhat TPDdot or Map dot means? anyway acceleration is the problem.
Re: Accel wizard.. MAP vs TP??
Posted: Wed May 19, 2010 7:10 pm
by drmiller100
4 injectors?
one throttle plate?
Intercooler?
does it try to go, then fade off, or does it just cough or stumble? If you run the engine generally richer, does it get better?
Re: Accel wizard.. MAP vs TP??
Posted: Thu May 20, 2010 4:28 am
by Matt Cramer
Do you have a data log of hammering on it that shows the AFR readings? If so, please post that along with your MSQ. I may have a few pointers.
You can also find some advice for setting up AE at this link:
http://www.megamanual.com/ms2/tune.htm#accel
Re: Accel wizard.. MAP vs TP??
Posted: Tue May 25, 2010 2:31 pm
by HPjunkie
4, 55lb injectors, single throttle body, no intercooler. I was wondering about plenum size. Its mainly off of idle while letting the clutch out. What are you accel settings?