EDIS woes- stuck in limp mode
Forum rules
Read the manual to see if your question is answered there before posting. Many users will not reply if the answer is already available in the manual.
If your question is about troubleshooting, configuration, or tuning, you MUST include your processor type (MS-I or MS-II) and code version in your post. If your question is about PCB assembly or modifications, you must also include the main board version number (1.01, 2.2 or 3.0). For tuning/troubleshooting questions, please attached a datalog and your MSQ file to your post.
If you have questions about MS1/Extra or MS2/Extra code configuration or tuning, please post them at www.msextra.com Such questions posted here will be moved to: a temporary MSextra sub-forum, where they will be removed after 7 days
The full forum rules are here: Forum Rules, be sure to read them all regularly.
Read the manual to see if your question is answered there before posting. Many users will not reply if the answer is already available in the manual.
If your question is about troubleshooting, configuration, or tuning, you MUST include your processor type (MS-I or MS-II) and code version in your post. If your question is about PCB assembly or modifications, you must also include the main board version number (1.01, 2.2 or 3.0). For tuning/troubleshooting questions, please attached a datalog and your MSQ file to your post.
If you have questions about MS1/Extra or MS2/Extra code configuration or tuning, please post them at www.msextra.com Such questions posted here will be moved to: a temporary MSextra sub-forum, where they will be removed after 7 days
The full forum rules are here: Forum Rules, be sure to read them all regularly.
-
sillywabbit
- MegaSquirt Newbie
- Posts: 2
- Joined: Tue Sep 07, 2010 7:41 pm
EDIS woes- stuck in limp mode
I have been running MSII with EDIS for about 8 months now. Everything was running great until I changed the cylinder head, and now I don't have any spark advance. No wiring was changed with regards to ignition. No ignition related MS settings were changed. I went back and checked all the connections, and they are all good. Could the control unit have failed? I'll check the MS board tomorrow to see if anything became unsoldered, but I suspect something else is going on. Has anyone else experienced this before?
VW rabbit, 1.8 bottom W/ ABA head, MSII V3.0 and EDIS for ignition, more coming soon
-
Matt Cramer
- Super Squirter
- Posts: 2951
- Joined: Sat Jul 03, 2004 11:35 am
Re: EDIS woes- stuck in limp mode
This is unlikely, but I'd check the ignition output on a Stim. If it's changed, try reloading the firmware and load an MSQ from before the problem happened.
-
sillywabbit
- MegaSquirt Newbie
- Posts: 2
- Joined: Tue Sep 07, 2010 7:41 pm
Re: EDIS woes- stuck in limp mode
Broken jumper wire inside megasquirt. Thanks for the help.
VW rabbit, 1.8 bottom W/ ABA head, MSII V3.0 and EDIS for ignition, more coming soon