MSefi.com read only forum (Jan.15,2018)

Posted: **Thu Oct 21, 2010 1:43 pm**

i have a olds 455 i am trying to put a ford edis ignition on.
i bought this
<eBay links not allo0wed on these forums>
36-1 6.75 inch wheel of of ebay. I need to drill mounting holes for it but i cant figure out where the missing tooth should be mounted in relation to TDC.
I've searched but cant come up with anything
thanks in advance
brad

Posted: **Thu Oct 21, 2010 3:01 pm**

http://www.megamanual.com/ms2/EDIS.htm

The picture shows the relationship between TDC, wheel and sensor for an 8 cylinder. Further down it gives the differences for 4 and 6 cylinder engines.

Posted: **Thu Oct 21, 2010 4:01 pm**

so 5 teeth ahead of tdc

Posted: **Fri Oct 22, 2010 12:13 am**

hessdawg wrote:so 5 teeth ahead of tdc

Yes. But note how that diagram is viewed.

MSefi.com read only forum (Jan.15,2018)

36-1 wheel phasing

36-1 wheel phasing

Re: 36-1 wheel phasing

Re: 36-1 wheel phasing

Re: 36-1 wheel phasing