Page 1 of 1
Help me
Posted: Fri Oct 22, 2010 1:36 am
by practician
Hello. I want to use megasquirt system, but can't find some info about sensors.
For example: if i connect to megasquirt ignition only, what sensors do i need?
Or squirt only.
Can someone help me?
sorry for my bad English
Re: Help me
Posted: Fri Oct 22, 2010 4:24 am
by Matt Cramer
practician wrote:Hello. I want to use megasquirt system, but can't find some info about sensors.
For example: if i connect to megasquirt ignition only, what sensors do i need?
Or squirt only.
Can someone help me?
sorry for my bad English
The V3.0 wiring diagram on this page shows the standard sensors it would be using for fuel and ignition:
http://www.megamanual.com/v22manual/mwire.htm
The MAP sensor, being inside the MS, isn't shown. A fuel-only setup could use the V2.2 diagram instead, while an ignition-only setup can omit the IAT, CLT, O2, and TPS sensors.
Re: Help me
Posted: Fri Oct 22, 2010 6:27 am
by practician
Thanks very much,
One question more:
Why isn't camshaft position sensor on picture (External Wiring)?
Is it not necessary?
Re: Help me
Posted: Fri Oct 22, 2010 7:30 am
by trakkies
practician wrote:Thanks very much,
One question more:
Why isn't camshaft position sensor on picture (External Wiring)?
Is it not necessary?
It is shown as getting the tach signal from the coil. Other ignition systems are covered separately.
Re: Help me
Posted: Sat Oct 23, 2010 12:57 am
by practician
thanks