MSefi.com read only forum (Jan.15,2018)

Posted: **Thu Dec 23, 2010 7:38 am**

My car has been sitting for about 1.5 years. Upon firing it up the other day, I noticed the LC-1 was not working.

I whent through the steps for free air cal. and I did not get an E2 code. When the key is turned to the ON posistion, There are just three bars displayed on the gauge. When I push the button on the gauge, I will get a HI or LO but nothing else.

Keith

Posted: **Sun Dec 26, 2010 4:27 pm**

anyone??

Posted: **Mon Dec 27, 2010 6:07 am**

Can it communicate with LogWorks?

Posted: **Mon Dec 27, 2010 8:02 am**

I'm not sure I even have that capability. I have the CD with the LC-1 manual. Is there a program in there that I can try to connect to?

Posted: **Mon Dec 27, 2010 12:07 pm**

toon1 wrote:I'm not sure I even have that capability. I have the CD with the LC-1 manual. Is there a program in there that I can try to connect to?

Yes, that would be LogWorks.

Posted: **Mon Dec 27, 2010 1:30 pm**

OK, thanks Matt, I will check it out. Keith

MSefi.com read only forum (Jan.15,2018)

LC-1 not working

LC-1 not working

Re: LC-1 not working

Re: LC-1 not working

Re: LC-1 not working

Re: LC-1 not working

Re: LC-1 not working