MSefi.com read only forum (Jan.15,2018)

Posted: **Thu Jan 13, 2011 1:56 pm**

Does the 3.57 board not have the JS10 jumper or am I missing it? I am going by these directions listed below:

* Remove the jumper from JS10 to IGN (if exists)
* Jumper IGBTIN to JS10
* Jumper IGBTOUT to IGN

Posted: **Fri Jan 14, 2011 5:14 am**

JS10 is there; IGN is not. The center hole of the Q16 slot is connected directly to pin 36 on the DB37.

Posted: **Sat Jan 15, 2011 6:42 pm**

Ok thanks, I couldn't find it cause it wasn't there.

MSefi.com read only forum (Jan.15,2018)

3.57 board - IGBT High Current Ignition Coil Driver Circuit

3.57 board - IGBT High Current Ignition Coil Driver Circuit

Re: 3.57 board - IGBT High Current Ignition Coil Driver Circ

Re: 3.57 board - IGBT High Current Ignition Coil Driver Circ