Page 1 of 1
output test mode
Posted: Tue May 10, 2011 12:44 pm
by naavwz
hello.
Let me introduce my self I'm Marcel and I drive a Volkswagen 16V.
I use a ms v3 board.
Well I have problems with the output test mode in megatune
When I want to test injectors or ignition they do nothing and my board quit
Yesterday did everthing succesfully
and today I want to test again and evertime I try my board quit
What could be the problem
thanks in advance
Re: output test mode
Posted: Wed May 11, 2011 3:58 am
by Matt Cramer
What processor version and firmware are you running?
Re: output test mode
Posted: Wed May 11, 2011 9:54 am
by naavwz
my processor is ms2 v3.0
and i'm using megatune version 2.25
I have been reading another forum where they say you need to download tunerstudio for a better communication with your computer
is that true because I have that not yet
greats marcel
Re: output test mode
Posted: Wed May 11, 2011 10:54 am
by Matt Cramer
And what firmware version has been loaded to your MS2?
Re: output test mode
Posted: Wed May 11, 2011 11:15 am
by LT401Vette
I have been reading another forum where they say you need to download tunerstudio for a better communication with your computer
is that true because I have that not yet
There is no assurance communication with your computer will be better, but it is certainly easier to set up, configure and use.
Re: output test mode
Posted: Thu May 12, 2011 6:57 am
by naavwz
Matt,
I have looked in my comp and I think my firmware version is 20071020
I hope you mean this
greats marcel
Re: output test mode
Posted: Fri May 13, 2011 4:04 am
by Matt Cramer
That doesn't sound like a firmware version either, sorry.
Re: output test mode
Posted: Fri May 13, 2011 4:53 am
by LT401Vette
Check the title bar while connected to the controller.
Re: output test mode
Posted: Tue May 17, 2011 12:29 pm
by naavwz
anyway, thanks for the support